ItH motor thermal protection current 6 - Start : the speed is displayed in Hertz (Hz) for example, for a 3000 rpm / 50 Hz motor : 20 Hz = 1200 rpm.SP2 and SP3 speeds if necessary for 4 preset speeds.acceleration ACC and deceleration dEC ramps.speed reference, via LI3/LI4 and/or via a potentiometer on AI1 3 - Power up without giving a run signal 4 - Configure the motor nominal frequency bFr if it is other than 50 Hz 5 - Adjust, if the factory setting is not suitable :.control (1 or 2 operating directions via LI1 and/or LI2).motor (U - V - W - s) ensuring that it is connected to a 200/240 V supply.Antes de intervenir en el variador,ġ - Mount the controller 2 - Connect according to the circuit diagram below : Prima di intervenire togliere l'alimentazione, attendere 1 min. Vor Eingriff ist das Gerä spannungslos zu machen, 1 min warten. Before servicing remove all power, wait 1 min. Avant toute intervention, couper la puissance, attendre 1 mn. Installation : - device vertical, ± 10° - minimum clearance for cooling : 50 mm around the controller 10 mm in front
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |